ipod Nano Case
Yarn
Size 5 needles
A cute button
A needle to sew the sides with
Crochet hook
I am not exactly sure how many stitches you will need to cast on, but just make sure that it is about 1.5 inches wide (or the width of the ipod nano).
Then continue to just knit down until it is about 7 inches long (or twice the length of the Ipod). After that, continue to knit, but at the begining of the next row, knit 2 together.
Then knit the whole next row till the end, then knit 2 together at the end of that row. Continue to do this, making a slight V out of the end of the yarn.
When there is only 1 loop left on the knitting needle, switch to crochet hook, making a chain that is about 5 inches long, then cut it off.
Sew the sides together, turning it right side out when you are done (make sure not to sew the V part or the string).
Then sew the button onto the front of the case, about near the tip of the V (the string at the end is used to wrap around the button).
I am sorry if these were a little confusing...when I made this I wasn't really planning on
making actual instructions, so I had to remind myself. I hope you enjoy it!
Like this project? Then share it on Facebook!
This project was submitted by socksrule2006 (Jessica). Thanks Jessica!
this is so cool!!! i made something that was very similar! only it was chrochet
Thanks, great pattern. Perfect for my brand new ipod. I just knitted the case in a couple of hours and I'm brand new to knitting, so it's really easy! :-)
I think an iPod case should have a way to acses the scrolly and screen.
raspberry, I don't remember what size specifically...just somewhere between average size and small. All you use it for is to make the string that wraps around the button to close it.
i was just wondering what size of crochet hook to use?
hey guest #1: i do too! thanks socksrule2006
love it...i have a hot pink iPod nano! adorable- thanks for the pattern!:)!