Dark Love Necklace

1. Take 22cm (8.7") of the chain. Using one 6mm jump ring attach one part of the toggle clasp to the chain.
2. Use 7cm (2.75") of wire to form a wrapped loop that attaches to the free end of the chain piece.
3. String 1 photobead and make a wrapped loop that attaches to one end of a 2cm (0.8") chain piece.
4. Repeat step 2, step 3 and step 2 again.
5. String 1 photobead and make a wrapped loop that attaches to one end of a 9cm (3.5") chain piece.
6. Use 4cm (1.65") of wire to form a wrapped loop that attaches to the free end of the 9cm chain piece. String one black glass bead and make a wrapped loop. Use 4cm (1.65") of wire to form a wrapped loop that attaches to the loop you made for the first black bead. String the second black bead and make a wrapped loop that attaches to the last piece of chain.
8. Using the second 6mm jump ring attach the second part of the clasp.
9. Attach (sew) the flower to the chain between photobeads and black beads using thread and needle. Hide the excess thread inside the flower. Trim the thread ends if they are too long.

This project was submitted by Photobeads

  

This project was submitted by photobeads (Alexandra). Thanks Alexandra!

Leave your comment on this project (no HTML and keep comments to 255 characters or less). While a rating is required, an actual comment is optional.

Rate this project (Click on a star) (Required):

  Check this box to be notified when new comments are added to this project